[Bioperl-l] Parsing needle/water output

Scott Markel SMarkel at accelrys.com
Thu May 14 19:58:32 UTC 2009


Shalabh,

Have you looked at Bio::AlignIO::emboss?

Scott

Scott Markel, Ph.D.
Principal Bioinformatics Architect  email:  smarkel at accelrys.com
Accelrys (SciTegic R&D)             mobile: +1 858 205 3653
10188 Telesis Court, Suite 100      voice:  +1 858 799 5603
San Diego, CA 92121                 fax:    +1 858 799 5222
USA                                 web:    http://www.accelrys.com

http://www.linkedin.com/in/smarkel
Vice President, Board of Directors:
    International Society for Computational Biology
Co-chair: ISCB Publications Committee
Associate Editor: PLoS Computational Biology
Editorial Board: Briefings in Bioinformatics


> -----Original Message-----
> From: bioperl-l-bounces at lists.open-bio.org [mailto:bioperl-l-
> bounces at lists.open-bio.org] On Behalf Of shalabh sharma
> Sent: Thursday, 14 May 2009 12:54 PM
> To: bioperl-l
> Subject: [Bioperl-l] Parsing needle/water output
> 
> Hi All,
>          Is there any parser/module available to parse needle/water output
> report (from emboss) to get the start and end position of alignment.
> 
> Thanks
> Shalabh
> _______________________________________________
> Bioperl-l mailing list
> Bioperl-l at lists.open-bio.org
> http://lists.open-bio.org/mailman/listinfo/bioperl-l




More information about the Bioperl-l mailing list