[Bioperl-l] Parsing needle/water output

shalabh sharma shalabh.sharma7 at gmail.com
Thu May 14 16:13:33 EDT 2009


yes, i tried to read the documentation about Bio::AlignIO::emboss, but there
is not much in it.So is like i can call the same functions which are used in
searchIO. I need start and end position of the pairwise alignment.

Thanks
Shalabh


On Thu, May 14, 2009 at 3:58 PM, Scott Markel <SMarkel at accelrys.com> wrote:

> Shalabh,
>
> Have you looked at Bio::AlignIO::emboss?
>
> Scott
>
> Scott Markel, Ph.D.
> Principal Bioinformatics Architect  email:  smarkel at accelrys.com
> Accelrys (SciTegic R&D)             mobile: +1 858 205 3653
> 10188 Telesis Court, Suite 100      voice:  +1 858 799 5603
> San Diego, CA 92121                 fax:    +1 858 799 5222
> USA                                 web:    http://www.accelrys.com
>
> http://www.linkedin.com/in/smarkel
> Vice President, Board of Directors:
>    International Society for Computational Biology
> Co-chair: ISCB Publications Committee
> Associate Editor: PLoS Computational Biology
> Editorial Board: Briefings in Bioinformatics
>
>
> > -----Original Message-----
> > From: bioperl-l-bounces at lists.open-bio.org [mailto:bioperl-l-
> > bounces at lists.open-bio.org] On Behalf Of shalabh sharma
> > Sent: Thursday, 14 May 2009 12:54 PM
> > To: bioperl-l
> > Subject: [Bioperl-l] Parsing needle/water output
> >
> > Hi All,
> >          Is there any parser/module available to parse needle/water
> output
> > report (from emboss) to get the start and end position of alignment.
> >
> > Thanks
> > Shalabh
> > _______________________________________________
> > Bioperl-l mailing list
> > Bioperl-l at lists.open-bio.org
> > http://lists.open-bio.org/mailman/listinfo/bioperl-l
>



More information about the Bioperl-l mailing list